我正在使用 NXP 的 Kinetis KEA64 微控制器。
时钟的实际频率为 20MHz，每 2.5ms 产生一次定时器中断。我有一个中断处理程序，可以在生成此定时器中断时切换 LED。LED 在此定时器中断上切换，但我不确切知道 LED 的频率。我的 LED 是否以 5kHz 切换？这是对的吗？
void interrupt_application_timer_FTM0()
{
SIM_SCGC |= SIM_SCGC_FTM0_MASK; /* Enable Clock for FTM0 */
FTM0_SC |= FTM_SC_PS(7); /* Select Preescaler in this case 128. 20 Mhz /128 =156.25 Khz. */
/* Counter increase by one every 6.4 us */
/* Enable Channle 0*/
FTM0_C0SC |= FTM_CnSC_CHIE_MASK; /* Enable channel 0 interrupt */
FTM0_C0SC |= FTM_CnSC_MSA_MASK; /* Channel as Output compare mode */
/*Select interrupt frequency*/
FTM0_C0V = FTM_CnV_VAL(391) ; /* Interrupt every 2.5ms */
FTM0_SC |= FTM_SC_CLKS(1); /*FTM0 use system clock*/
/* Set the ICPR and ISER registers accordingly */
NVIC_ICPR |= 1 << ((INT_FTM0-16)%32);
NVIC_ISER |= 1 << ((INT_FTM0-16)%32);
}
这是我的中断处理程序
void FTM0_IRQHandler()
{
if (1==((FTM0_C0SC & FTM_CnSC_CHF_MASK)>>FTM_CnSC_CHF_SHIFT) ) /* If the CHF of the channel is equal to 0 */
{
(void)FTM0_C0SC; /* Read to clear flag */
FTM0_C0SC ^= FTM_CnSC_CHF_MASK; /* Clear flag */
FTM0_C0V = FTM0_C0V + 391 ; /* Refresh interrupt period */
if (LED_counter>=50){
/* Toggle LED */
/* Reset counter */
LED0_TOGGLE;
LED_counter = 0;
}
LED_counter++;
}
}