我正在开发一个项目,该项目从通用源读取数据,使用 swing 形成图像,然后将图像(一行图像)转换为 escpos 命令并将其发送到打印机。
要将图像传输到 escpos 代码,我使用了java-escpos-image-printing材料,但稍作改动:
int n = 0;
bos.write(printerSchema.getLineSpace24());
for (int y = 0; y < image.length; y += 24) {
// Like I said before, when done sending data,
// the printer will resume to normal text printing
if (n == 2) {
bos.write(printerSchema.getCutPaper());
}
bos.write(printerSchema.getImageMode());
// Set nL and nH based on the width of the image
bos.write(new byte[] { (byte) (0x00ff & image[y].length), (byte) ((0xff00 & image[y].length) >> 8) });
for (int x = 0; x < image[y].length; x++) {
// for each stripe, recollect 3 bytes (3 bytes = 24 bits)
bos.write(recollectSlice(y, x, image));
}
// Do a line feed, if not the printing will resume on the same
// line
bos.write(printerSchema.getLineFeed());
n++;
更改是一个“剪纸命令”,应该在绘制第二条线后启动(实际上,打印机在切刀和打印头之间有很大的空间)。
一切似乎都工作正常,但有时我随机收到缺少的第二行(总是在剪纸命令之前),有时缺少空格(第一行和第三行只是放在一起),有时还有一个空格。
打印机:Sam4s Giant-100 命令:
INIT_PRINTER = new byte[]{0x1B,0x40},//1B 40 Initialize printer
IMAGE_MODE = new byte[] { 0x1B, 0x2A, 33 }, LINE_FEED = new byte[] { 0x0A },
LINE_SPACE_24 = new byte[] { 0x1B, 0x33, 24 }, LINE_SPACE_30 = new byte[] { 0x1B, 0x33, 30 },
CUT_PAPER = new byte[] { 29, 86, 1 }; // 1B 33 n
将问题定位到零件
if (n == 2) { bos.write(printerSchema.getCutPaper()); } 在它没有被绘制之前的线。